Thermodynamics Mock Test – NEET Physics
GKaim: Measure | Improve | Achieve

Thermodynamics Mock Test – NEET Physics

Progressive Test — Guest First Round

0%

Thermodynamics – Progressive Test

Welcome to the Progressive Test.

Click Start Test to begin the loaded practice round.

Good luck!

1 / 50

1. A gas executes the rectangular cycle described below on a diagram.

Starting at , the gas expands at pressure from to , where . It then undergoes a constant-volume pressure decrease to , is compressed at pressure back to , and finally undergoes a constant-volume pressure increase to .

What is the net work done by the gas in one cycle?

2 / 50

2. The same fixed amount of ideal gas starts from state and reaches either state or state . States and have the same final temperature. Along path , the gas absorbs of heat and does of work. Along path , the work done by the gas is . What heat transfer is required along ?

3 / 50

3. A system undergoes the following three successive energy-transfer events.

Event Description
I enters from a hotter reservoir because of a temperature difference.
II enters through mechanical stirring while the system is thermally insulated.
III leaves as heat to a colder reservoir.

Using the adopted heat-sign convention, what is the net heat transfer for the complete sequence?

4 / 50

4. Two quasi-static paths connect the same initial state at volume to the same final state at volume .

On a plot, Path lies entirely above Path between and , except at the common endpoints. Both paths involve expansion throughout.

Which statement is necessarily correct?

5 / 50

5. A gas undergoes the following quasi-static sequence on a diagram.

Stage I: expansion from to at . Stage II: compression from to at . Stage III: expansion from to while pressure decreases linearly from to .

What is the total work done by the gas?

6 / 50

6. Bodies and are placed in conducting contact and allowed to reach thermal equilibrium. They are then thermally separated from each other. Next, is brought into conducting contact with a colder body and the pair is allowed to reach thermal equilibrium while remains isolated. Which statement is necessarily correct at the end?

7 / 50

7. A fixed amount of ideal gas is contained in a rigid vessel. Initially it is at temperature . Stage I is carried out with the vessel thermally insulated while an external paddle wheel does of work on the gas. In Stage II the paddle is disconnected and the rigid vessel is placed in contact with a large reservoir at until the gas returns to its initial state. Which statement is correct?

8 / 50

8. A proposed cyclic device absorbs of heat from a single reservoir and delivers of work to the surroundings. It produces no other change anywhere. Which assessment is correct?

9 / 50

9. A gas in a thermally insulated, frictionless piston-cylinder initially has pressure , while the external pressure is suddenly changed to . The gas expands until a new equilibrium is reached. Which statement is correct?

10 / 50

10. A system goes from state to state by three different paths. Using for heat supplied to the system and for work done by the system, the data are:

Path
P
Q
R

What value of is required if all three paths genuinely connect the same states?

11 / 50

11. A gas is taken from state to state by two different quasi-static paths. Along Path 1, the gas does of work. Along Path 2, it does of work. Which conclusion follows solely from these data?

12 / 50

12. An ideal gas undergoes two consecutive quasi-static isothermal stages at the same temperature. First it is compressed from to , and then it expands from to . For the gas, . Take . What are the net work done by the gas and the net heat supplied over both stages?

13 / 50

13. A fixed amount of ideal gas undergoes a reversible isothermal expansion from pressure to . If its initial volume is , which pair correctly gives the final volume and work done by the gas?

14 / 50

14. Consider the following statements.
Statement I: Heat is a process quantity and is not a thermodynamic quantity stored in a system as part of its state description.
Statement II: Whenever the temperature of a system rises, heat must necessarily have been supplied to it.

15 / 50

15. The same amount of an ideal gas undergoes isothermal expansion from to in two separate experiments. The temperatures are and , respectively. Let the corresponding works be and . At any common volume , let the pressures on the two isotherms be and . Which relation is correct?

16 / 50

16. A gas is compressed quasi-statically from to while its pressure increases linearly from to . During the process the gas rejects of heat. What is the change in internal energy?

17 / 50

17. Two quasi-static paths and connect the same equilibrium states and . Along , the gas does of work and absorbs of heat. Along , the area shows that the gas does only of work. How much heat is absorbed along ?

18 / 50

18. A gas is heated in a rigid sealed vessel. Its pressure rises substantially while its volume remains fixed. Which statement about pressure-volume work is correct?

19 / 50

19. Four proposed processes involve the same fixed amount of ideal gas.

Process Given information
I Expansion with
II Compression with
III Expansion with but
IV Fixed volume, constant temperature, no other work mode, with

Which process is fully consistent with an isothermal ideal-gas process?

20 / 50

20. Use the arrangement described below.

Systems and are separated from each other by an adiabatic wall. Each is in thermal contact with a third system through a conducting wall. After sufficient time, both are in thermal equilibrium with . System is then insulated from them and the wall between and is replaced by a conducting wall.

Assertion: No further temperature-driven change occurs in and immediately after they are placed in conducting contact.
Reason: Their earlier equilibria with imply and , and hence .

21 / 50

21. Two bodies and have temperatures and are placed in thermal contact. Which process is consistent with the second law when no external work or other effect occurs?

22 / 50

22. During a non-cyclic expansion, a gas absorbs heat from a reservoir and converts part of that transferred energy into work while its internal energy also changes. A student claims that any conversion of heat into work violates the Kelvin-Planck statement. Which evaluation is correct?

23 / 50

23. A sealed container of gas initially rests on a laboratory table. In Stage I the entire container is accelerated until it moves uniformly, while its internal thermodynamic state remains unchanged. In Stage II, while moving uniformly, of heat is supplied to the gas in a rigid container and no other microscopic energy transfer occurs. Which statement is correct?

24 / 50

24. The same ideal gas starts from the same state and expands quasi-statically to the same larger volume by two paths.

Path I is isothermal. Path II is reversible adiabatic. Both begin at the same point on the plane and terminate when the gas reaches the same final volume .

Which comparison is correct?

25 / 50

25. A fixed amount of ideal gas undergoes a reversible adiabatic expansion in which its pressure falls from to . The gas has . What are the corresponding ratios and ?

26 / 50

26. A large system at possesses greater total internal energy than a smaller system at . Initially they are separated by an adiabatic wall. Later that wall is replaced by a conducting wall, and the systems are allowed to reach thermal equilibrium. Which description is correct?

27 / 50

27. Four thermally insulated ideal-gas processes are described.
Statement I: The gas expands through a frictionless piston in an idealised quasi-static manner with an infinitesimal pressure imbalance.
Statement II: The gas freely expands into an evacuated chamber.
Statement III: The gas expands suddenly against a finite external pressure difference.
Statement IV: The gas is compressed very slowly by a piston but appreciable friction acts throughout.
For which process is the standard reversible adiabatic relation directly applicable?

28 / 50

28. Assertion: The Kelvin-Planck and Clausius statements are equivalent formulations of the second law.
Reason: If a device violating either statement could exist, it could be coupled with an otherwise suitable cyclic device to construct a net process violating the other statement.

29 / 50

29. Two bodies at and are placed in direct thermal contact inside an otherwise isolated enclosure and eventually reach a common temperature. Which statement about the process is correct?

30 / 50

30. Match each proposed outcome in List I with the most appropriate classification in List II.

List I List II
P. Cyclic device takes heat from one reservoir and converts it completely into work with no other effect 1. Clausius violation
Q. Heat moves from a cold reservoir to a hot reservoir with no other effect 2. Kelvin-Planck violation
R. Heat moves from cold to hot while external work is supplied 3. Not forbidden merely by the Clausius statement
S. A cyclic engine absorbs heat from a hot reservoir, does work and rejects some heat to a colder reservoir 4. Not of the forbidden complete single-reservoir conversion form

31 / 50

31. A sealed container of gas is initially at rest and in a definite thermodynamic state. Without deforming or heating the container, an external agent gives the entire container a uniform translational velocity . Which statement about the gas is correct immediately afterward?

32 / 50

32. Two thermometers and have negligible thermal effect on a large body . Before measurement, is at and is at . In separate trials, 's reading rises and becomes steady at , whereas 's reading falls and becomes steady at . Which conclusion is most appropriate?

33 / 50

33. A system undergoes two successive stages. During Stage I it absorbs of heat and does of work. During Stage II it rejects of heat while the surroundings do of work on it. Which conclusion is correct for the complete two-stage process?

34 / 50

34. A cyclic machine claims to absorb from a single thermal reservoir and deliver of mechanical work every cycle while returning to its original state. Consider the following statements.
Statement I: Its first-law energy balance is satisfied.
Statement II: Its operation is forbidden by the Kelvin-Planck statement.
Statement III: The impossibility arises because energy is not conserved.
Statement IV: Returning to the original state implies .
Which combination is correct?

35 / 50

35. A cyclic device follows a clockwise closed path on a diagram and the enclosed area is . The device returns to its original thermodynamic state after every cycle. It is claimed that its only external thermal interaction is absorption of from a single reservoir, all of which appears as work output. Which assessment is correct?

36 / 50

36. A large body at has greater total internal energy than a much smaller body at . The two are brought into conducting thermal contact. Which statement is correct immediately after contact?

37 / 50

37. Three different quasi-static expansion paths connect the same equilibrium states and .

Throughout the common volume interval, Path lies above Path , and Path lies above Path . The paths have the same endpoints but different areas under their curves.

If the heats supplied are , which ordering must hold?

38 / 50

38. Consider the following statements about cyclic devices.
Statement I: A cyclic device that absorbs from a single reservoir and produces of work with no other effect satisfies the first-law balance but violates the Kelvin-Planck statement.
Statement II: If a cyclic device instead absorbs from a hot reservoir, produces of work and rejects to a colder reservoir, its stated energy balance is first-law consistent and it no longer has the Kelvin-Planck forbidden sole-result form.
Which evaluation is correct?

39 / 50

39. Systems and are separated from each other by an adiabatic wall. System is separately allowed to reach thermal equilibrium with system , and system is also allowed to reach thermal equilibrium with the same system in the same thermal state. The pressures and volumes of and are not equal. After these equilibria are established, is thermally isolated and the wall is replaced by a conducting wall. What should be expected?

40 / 50

40. The same ideal gas starts from and is taken to the common final state by two routes. Route is an insulated free expansion directly to . Route is a reversible adiabatic expansion to with , followed by heating at constant volume until the temperature again becomes . Which comparison of the total heat and total work done by the gas is correct?

41 / 50

41. Match each process condition in List I with the most appropriate conclusion in List II.

List I List II
P. Frictionless piston, infinitesimal pressure imbalance, thermally insulated cylinder 1. Reversible adiabatic idealisation
Q. Very slow piston motion with appreciable friction 2. Quasi-static-looking but irreversible because of dissipation
R. Heat transfer through a finite temperature difference 3. Irreversible thermal transfer
S. Frictionless quasi-static isothermal expansion with infinitesimal thermal driving difference 4. Reversible isothermal idealisation

42 / 50

42. An ideal gas starts at and completes the following cycle. From to , it expands reversibly and adiabatically to with . From to , it is compressed isothermally at temperature back to volume . From to , it is heated at constant volume. What is the net work done by the gas in one cycle?

43 / 50

43. Two systems and are placed in thermal communication and allowed sufficient time to interact. Which observation identifies that they have attained thermal equilibrium with each other?

44 / 50

44. An ideal gas initially has and . It expands quasi-statically and isothermally to . Take . What heat is supplied to the gas?

45 / 50

45. Two isolated bodies and begin at and , respectively. From to they are separated by a conducting wall. Before equilibrium is reached, the wall is made adiabatic from to . At , the conducting wall is restored and remains so thereafter. Use the graph description below.

The vertical axis is temperature and the horizontal axis is time. The required pair of temperature curves must represent the complete three-stage wall sequence.

Which qualitative behaviour is physically consistent?

46 / 50

46. Along Path 1 between two fixed equilibrium states, the heat supplied is twice the work done by the system:

Along Path 2 between the same states, the work done by the system is

What is ?

47 / 50

47. Two curves originate from the same point on a diagram and both move toward larger volume.

Curve X falls gradually with increasing volume. Curve Y falls more steeply and remains below X after leaving the common initial point. Both curves describe quasi-static processes of the same ideal gas starting from the same state.

If one curve is isothermal and the other is reversible adiabatic, which identification is correct?

48 / 50

48. Consider the following temperature-time observation.

The vertical axis represents temperature and the horizontal axis represents time. Curve begins at and decreases smoothly. Curve begins at and increases smoothly. The two curves meet at and remain horizontal together thereafter. A third isolated system has remained at throughout. After and have reached their common horizontal portion, is placed in conducting contact with both.

Which statement is correct?

49 / 50

49. A hypothetical coupled-device arrangement consists of a Clausius-violating device and a cyclic heat engine . Device transfers from a cold reservoir to a hot reservoir without any work input or other net effect. Engine absorbs from the hot reservoir, produces of work and rejects to the cold reservoir. What is the combined net result of operating both devices?

50 / 50

50. An ideal gas at temperature undergoes the following sequence:
Stage I: Reversible isothermal expansion from to .
Stage II: Free expansion in an insulated enclosure from to .
Stage III: Reversible isothermal compression from back to .
If , which set gives the net work done by the gas, the net heat supplied, and the character of the complete cycle?

Your score is

Share your achievement!

LinkedIn Facebook
0%

Complete 100% of the Progressive Test coverage to unlock Mistake Review.
Complete 100% of the Progressive Test coverage to unlock Certificate Challenge.
Subscribe
Notify of
guest
0 Comments
Scroll to Top