Airport Engineering Online Test - Paper 2 »🎓 Test Knowledge

Created by

Vikash chaudhary

This is a FREE online test. Beware of scammers who ask for money to attend this test.

Get fresh, new questions in each attempt.

Total Questions: 30
Time Allotted: 30 minutes
Passing Score: 50%
Randomization: Yes
Certificate: No
Do not refresh the page!
👍 All the best!

1 / 30

1. The airplane of IAR was hijacked from Tribhuvan International Airport in

a) 1998

b) 1999

c) 2000

d) 2001

2 / 30

2. The name of the first plane that landed on the old golf course, which makes the present location of Tribhuvan International Airport is

a) twinatter

b) glider

c) boing

d) helicopter

3 / 30

3. What is the function of aircraft drainage?

a) To remove surface runoff

b) To lower the sub-surface water level

c) To intercept & divert the surface and ground water flow

d) All of the above

4 / 30

4. Pick up the component not applicable to airplanes

a) wings

b) fuselage

c) air screw

d) none of the above

5 / 30

5. The runway length of Tribhuvan International Airport is

a) 8990 ft

b) 10990 ft

c) 12990 ft

d) 14990 ft

6 / 30

6. Nose hanger is used normally for the accommodation of

a) Small

b) Large

c) Both (a) and (b) of above

d) None of the above

7 / 30

7. Maximum difference in elevation between the highest and lowest point of the runway divided by the total length of the runway is known as

a) Effective gradient

b) Longitudinal gradient

c) Maximum gradient

d) Minimum gradient

8 / 30

8. The maximum number of airports is located in the district

a) Kathmandu

b) Morang

c) Okhaldhunga

d) Solukhumbu

9 / 30

9. As the elevation of the airport increases, the runway length

a) Increases

b) Decreases

c) Constant

d) All of the above

10 / 30

10. The enclosure/structure where an aircraft is kept for maintenance and repair is known as

a) Dome

b) Workshop

c) Hanger

d) Air pad

11 / 30

11. Which one is the correct sequence with respect to the name of the first airport in Nepal?

a) Old golf course Gauchar Tribhuvan Tribhuvan international

b) Tribhuvan Old golf course Gauchar Tribhuvan international

c) Gauchar Tribhuvan Old golf course Tribhuvan international

d) none of the above

12 / 30

12. The bearing of the longest line of a wind rose is S 45Â°E. The bearing of the runway will be numbered

a) 135Â°

b) 315Â°

c) 13

d) All of the above

13 / 30

13. Pick up the correct statement from the following

a) The minimum turning radius of the aircraft decides the size of the apron and the radius of the curves at taxi-ends

b) Takeoff and landing distances for an aircraft determine the minimum runway length

c) The length of the normal haul of the aircraft decides the frequency of operation

d) All of the above

14 / 30

14. Pick up the correct statement from the following:

a) Approximate geometric center of the landing area is called airport reference point

b) The boundaries of the horizontal surface and conical surface are marked with reference to the airport reference point

c) The location of the airport on a map is the position of the airport reference point

d) All of the above

15 / 30

15. In question 58 along with RL100 m, If the temperature at the airport site is 20Â°C then find the Runway length

a) 640 m

b) 645 m

c) 650 m

d) 600 m

16 / 30

16. In a very-density- airport, the characteristics load per landing gear in KN is:

a) 850

b) 700

c) 550

d) 400

17 / 30

17. The fastest mode of transport is

a) air

b) railway

c) highway

d) none of the above

18 / 30

18. Conical surface of the approach area rises outwards

a) 1 in 10

b) 1 in 15

c) 1 in 20

d) 1 in 25

19 / 30

19. The angle between the longitudinal axis of the fuselage and an inclined plane below which the views of the pilots are blocked by some part of the aircraft is known as

a) Pitch angle

b) Cockpit cutoff angle

c) Slope angle

d) Horizontal angle

20 / 30

20. Effective length of a runway is the distance between

a) Ends of the runway

b) Point of intersection of the obstruction clearance line and the extended plane of the runway surface and the other end of the runway

c) Point of intersection of the glide path and the extended plane of the runway surface and the other end of the runway

d) Ends of the clearway on either side

21 / 30

21. The proposed international airport in Nepal is

a) Biratnagar

b) Nijgarh (Bara)

c) Janakpur

d) Pokhara

22 / 30

22. The maximum value of the angle of turning of the nose gear for large jet aircraft is limited to

a) 20Â°

b) 30Â°

c) 45Â°

d) 60Â°

23 / 30

23. The CBR method is used to design

a) Flexible pavement

b) Rigid pavement

c) None of the above

d) All of the above

24 / 30

24. Pick up the correct statement from the following

a) The center line of the approach area coincides with that of the runway

b) Approach areas are measured in horizontal surfaces

c) The imaginary inclined plane which is directly above the approach area is called the approach surface

d) All of the above

25 / 30

25. For A, B, and C types of airports, the longitudinal gradient of the runway recommended by ICAO is:

a) 1%

b) 1.50%

c) 2%

d) 2.50%

26 / 30

26. As per ICAO recommendation, the minimum width of the safety area for instrumental runway should be:

a) 4.50m

b) 78m

c) 150m

d) 300m

27 / 30

27. Pick up the incorrect statement from the following

a) In single-engine airplanes, the engine is provided in the nose of the aircraft

b) In double-engine airplanes, one engine on either wing is placed symmetrically

c) In three-engine airplanes, two engines are placed on both wings, and one engine is placed in the tail

d) None of the above

28 / 30

28. Pick up the correct statement from the following

a) Airscrew converts the energy given by the engine into speed

b) The propellers driven by turbine engines are technically called turbo-props

c) The aircraft which obtains the thrust directly from the turbine engine is called turbo-jets

d) The aircraft which is fitted with a fan in front of the turbo-jet engine is called a turbo-fan propelled aeroplane

29 / 30

29. The angle between the longitudinal axis of the fuselage and the horizontal axis is called

a) Horizontal angle

b) Vertical angle

c) Pitch angle

d) All of the above

30 / 30

30. Pick up the correct statement from the following:

a) Runway edge from the landing side is called the threshold

b) Localizer indicates to the pilot his position with respect to the proposed alignment

c) The glide slope indicates the correct angle of descent

d) All of the above

Please provide accurate information so we can send your Achievement Certificate by mail.

NameEmailPhone Number

Your score is

Please provide your feedback.

Thank you for your valuable feedback.

Buy Airport Engineering MCQ PDF for Offline Study

Airport Engineering Online Test – Paper 2

Please provide accurate information so we can send your Achievement Certificate by mail.

Related MCQs