Properties Of Solids And Liquids Mock Test – NEET Physics
GKaim: Measure | Improve | Achieve

Properties of Solids and Liquids Mock Test – NEET Physics

Progressive Test — Guest First Round

0%

Properties of Solids and Liquids – Progressive Test

Welcome to the Progressive Test.

Click Start Test to begin the loaded practice round.

Good luck!

1 / 50

1. Equal geometric areas are created in two processes using interfaces of the same surface tension . Process P creates one new liquid-air interface of area . Process Q creates a soap film whose geometric area is . Neglect edge effects. What is the ratio of the required works ?

2 / 50

2. Match the thermos-flask feature in List I with the heat-transfer effect in List II.

List I List II
P. Evacuated space between the walls 1. Primarily reduces conduction through a solid contact path
Q. Silvered/shiny facing surfaces 2. Suppresses convection and strongly reduces gas conduction
R. Insulating stopper/support 3. Reduces radiative exchange

3 / 50

3. An ideal incompressible liquid flows upward from section P to section Q. Section Q is above P, and the static pressures at P and Q are equal. The speed at P is . Take . What are the speed at Q and the ratio ?

4 / 50

4. An open tank has horizontal cross-sectional area four times the area of a small outlet near its side. The outlet is below the free surface. Unlike the usual large-tank approximation, the downward speed of the free surface is not to be neglected. Assume ideal incompressible flow and take . What is the efflux speed?

5 / 50

5. Match List I with List II.

List I List II
P. Water circulating in a vessel because it is heated from below 1. Forced convection driven by a pump
Q. Coolant deliberately circulated through an automobile engine 2. Natural convection driven by buoyancy
R. Daytime sea-breeze circulation 3. Forced convection driven by a fan
S. Air deliberately blown over a hot component 4. Natural convection associated with differential coastal heating

6 / 50

6. A solid cube has side and coefficient of linear expansion . It contains a spherical cavity of volume . The solid is heated freely through . Assuming small isotropic expansion, which pair correctly gives the approximate increases in the cube's outer volume and the cavity volume?

7 / 50

7. Two materials P and Q remain linearly elastic up to their respective yield stresses.

Material Young's modulus Yield stress
P
Q

Which conclusion about their states just at the stated yield stresses is correct?

8 / 50

8. Two vertical capillaries P and Q are dipped into the same perfectly wetting liquid. Tube P has radius , and the liquid rises to height . Tube Q has radius . Neglect the meniscus volume. If and are the volumes of liquid raised above the external reservoir level, which relation is correct?

9 / 50

9. The lengths of two freely expanding rods A and B are plotted against temperature in degree Celsius. Both plots are straight lines described by metre and metre over the stated temperature range.

At what temperature do the rods have equal lengths, and which rod has the larger coefficient of linear expansion?

10 / 50

10. Four identical spherical liquid drops, each of radius , have the same total surface energy as one soap bubble of radius . The drop liquid and soap film have the same surface tension . What are and the ratio of the soap bubble's excess pressure to the excess pressure inside one of the liquid drops?

11 / 50

11. In the proportional region, the force-extension graph of a wire of length and diameter is a straight line of slope , where the slope means . Take . A second wire of the same material and same length has diameter times that of the first. What are the Young's modulus of the material and the force needed to extend the second wire by ?

12 / 50

12. A large open tank contains water, and a small orifice is located below the free surface. Assume ideal flow, negligible free-surface speed and . What is the speed of efflux?

13 / 50

13. An idealised aircraft is initially in level flight, with its Bernoulli lift exactly equal to its weight. The aircraft then changes operating condition so that both the upper-surface and lower-surface airflow speeds become times their original values, while air density and effective wing area remain unchanged. In the same ideal model, what is the aircraft's initial vertical acceleration after this change? Take .

14 / 50

14. Consider the following statements about steady conduction.
Statement I: Thermal conductivity is a material property, whereas the heat current also depends on geometry and temperature difference.
Statement II: Two series-connected sections carrying the same steady heat current can have different temperature gradients.
Statement III: Doubling the thickness of a single uniform insulating slab while keeping all other quantities fixed halves its steady conductive heat current.
Statement IV: For two different materials, the one with smaller thermal conductivity must necessarily have smaller specific heat capacity.
Statement V: Total heat transferred during a steady interval is .
Which statements are correct?

15 / 50

15. A blackbody is initially at . It is then heated to . Take Wien's displacement constant as

What are its approximate peak wavelengths at the two temperatures?

16 / 50

16. A U-tube manometer measures a fixed pressure difference between two gas chambers. On Earth, a liquid of density gives a level difference of when . On another planet, the same pressure difference with the same manometric liquid gives a level difference of . If the manometric liquid is then replaced on that planet by another liquid of density , what are the local gravitational acceleration and the new level difference?

17 / 50

17. In an experiment to determine a solid's specific heat capacity, a heater supplies a measured energy to a sample of mass , producing a measured temperature rise . During the experiment, an unaccounted energy is lost to the surroundings. A student nevertheless calculates

How does this value compare with the true specific heat capacity?

18 / 50

18. Twenty-seven identical liquid drops of radius and surface tension coalesce into one spherical drop without loss of liquid. The final liquid condition has surface tension . Compare the final excess pressure and final surface energy with the initial excess pressure of each small drop and the initial total surface energy of all drops.

19 / 50

19. Two dense spheres P and Q fall at terminal velocities through the same viscous liquid under the same gravitational field. Their terminal viscous-drag magnitudes are equal. The sphere-fluid density differences satisfy

If their radii are and terminal speeds are , which relation is correct?

20 / 50

20. Three bodies have heat capacities and initial temperatures:

Body Heat capacity Initial temperature
A
B
C

If all three are placed together in an isolated enclosure, let their equilibrium temperature be . In a separate repeat of the initial conditions, C is removed and only A and B are placed together, giving equilibrium temperature . What are , , and the heat gained by C in the first experiment?

21 / 50

21. Use the stress-strain graph description below.

For a metal, the curve is linear from O to A. From A to B it is nonlinear, but unloading still restores the original dimensions. B is the yield point or elastic limit. Point C lies beyond B in the plastic region. D is the maximum-stress point on the curve, and fracture occurs later at E.

If the specimen is loaded from O to C and then completely unloaded, which statement is correct?

22 / 50

22. Two Newtonian liquids P and Q are tested between the same parallel plates with the same plate area and fluid-layer thickness. The following data are obtained:

Liquid Upper-plate speed Required tangential force
P
P
Q
Q

In a second experiment with liquid Q, the plate area is doubled, the fluid-layer thickness is halved, and the upper-plate speed is . Which pair is correct for and the required force in the second experiment?

23 / 50

23. Four rods P, Q, R and S are separately connected between the same two maintained temperatures. Their cross-sectional areas, lengths and thermal conductivities are:

Rod Area Length
P
Q
R
S

The numerical units of are . Which ordering of steady heat currents is correct?

24 / 50

24. An isotropic solid is heated through . Its mass remains constant, and its density decreases by approximately . Assuming small expansion, what is its coefficient of linear expansion?

25 / 50

25. Consider the following statements concerning changes of state of a pure substance.
Statement I: During melting at the melting point under fixed relevant pressure, solid and liquid may coexist while heat is supplied without a temperature rise.
Statement II: During boiling at the boiling point, liquid and vapour may coexist.
Statement III: Sublimation denotes a direct transition between solid and vapour without passing through the liquid state.
Statement IV: The triple point corresponds to a unique condition at which solid, liquid and vapour can coexist.
Statement V: The boiling point of a liquid is independent of external pressure.
Which statements are correct?

26 / 50

26. Two wires P and Q of equal original length are connected in parallel between two rigid plates. Wire P has cross-sectional area and Young's modulus . Wire Q has cross-sectional area and Young's modulus . A total tensile force is applied gradually and the wires remain in their proportional regions. Which relation is correct?

27 / 50

27. A metal block at is placed in of water initially at . The final equilibrium temperature is . Neglect the calorimeter heat capacity and heat loss to the surroundings. Take

What is the specific heat capacity of the metal?

28 / 50

28. Three separate linear-elastic experiments use longitudinal, hydraulic and shear deformation. The corresponding elastic moduli are

The three specimens are loaded so that they store equal elastic energy per unit volume. If the corresponding stress magnitudes are , and the strain magnitudes are , which pair of ratios is correct?

29 / 50

29. A wire of cross-sectional area has Young's modulus and yield stress . It is required that the longitudinal strain must never exceed , even if the yield stress has not yet been reached. Assuming linear behaviour up to the relevant limit, what is the largest permitted tensile load?

30 / 50

30. In one experiment, a liquid flowing steadily through a tube has volume flow rate . In another experiment, a fluid whose density varies along the tube has steady mass flow rate . Which set of relations and SI units is correct?

31 / 50

31. A dense sphere has terminal speed while falling through a stationary liquid under Stokes-law conditions. Let

where is the weight and the buoyant force. An external force is now used to make the sphere move downward at constant speed . In another independent trial, an external force maintains constant downward speed . Which statement is correct?

32 / 50

32. In a hydraulic experiment, a small piston of area is above a large piston of area . Both outer faces are exposed to the same atmospheric pressure. An input force of produces a measured upward force of on the large piston. Take . Assuming an ideal static fluid, what is its density, and what large-piston force would be obtained with the same input force if the vertical separation were reduced to ?

33 / 50

33. A hot metal sample at is placed in of water at . The calorimeter is also initially at and has heat capacity . The final temperature is . Take

What specific heat capacity would be inferred for the metal if the calorimeter were incorrectly ignored, and what is the corrected value?

34 / 50

34. Two spheres P and Q are made of the same material and fall through the same liquid under Stokes-law conditions. Their terminal speeds satisfy

What are the ratios of their radii and terminal viscous-drag magnitudes?

35 / 50

35. A spherical liquid drop of radius is broken into identical smaller drops. Surface tension is , and . Which pair correctly gives the ratio of final total surface area to initial surface area and the work required to create the additional surface?

36 / 50

36. A sample of water and a calorimeter of heat capacity are initially at . A total of of heat is removed from the water-calorimeter system at a pressure for which the freezing point is . Take

Neglect heat exchange with anything outside the stated system. What is the final state?

37 / 50

37. An ordinary liquid whose density decreases on heating is contained in a vessel and heated locally from below. Which sequence best describes the establishment of natural convection?

38 / 50

38. A clean horizontal needle of length and mass is carefully placed on a water surface. Assume the maximum vertical surface-tension support is and neglect buoyancy. Initially . A detergent is then added, reducing the surface tension to . Take . Which conclusion is correct?

39 / 50

39. An isotropic solid has coefficient of linear expansion

For a small temperature rise of , which pair gives the approximate fractional increases in area and volume?

40 / 50

40. A Newtonian liquid is confined between two parallel plates of area separated by . Initially the lower and upper plates move in the same direction with speeds and , respectively. A tangential driving force of is required on the upper plate to maintain steady motion. The upper plate is then made to move at in the direction opposite to the lower plate, while all other conditions remain unchanged. Which pair is correct?

41 / 50

41. Eight identical liquid drops, each of radius , coalesce to form one spherical drop. The liquid has surface tension . Take . Neglect any energy loss other than the decrease in surface energy. What are the radius of the final drop, the energy released, and its excess pressure?

42 / 50

42. A uniform wire of cross-sectional area is in equilibrium under equal and opposite pulls of magnitude at its two ends. A second wire is subjected to equal and opposite pulls of magnitude and has cross-sectional area . What is the ratio of the tensile stress in the second wire to that in the first?

43 / 50

43. A sample is heated by a constant-power heater with negligible heat loss. In the solid state its specific heat capacity is , and its temperature rises through in . It then melts at constant temperature for . After complete melting, the liquid temperature rises through in . What are the heater power, latent heat of fusion and liquid specific heat capacity?

44 / 50

44. A U-tube manometer contains mercury of density . One arm is open to an atmosphere of pressure , while the other is connected to a gas. On Earth, where , the mercury surface on the gas side is higher than the mercury surface on the atmospheric side. If the same atmospheric and gas pressures are maintained on another planet where , which pair is correct?

45 / 50

45. A small horizontal piston of area is situated below the free surface of water in an open tank. The other side of the piston is exposed to the atmosphere. Take and . What net force acts on the piston due to the pressure difference?

46 / 50

46. A dense small sphere is released from rest in a viscous liquid under conditions where Stokes' law applies. Which sequence best describes its subsequent downward motion?

47 / 50

47. A helical spring and a lump of putty are separately deformed by moderate external forces. After the forces are removed, the spring returns to its original form while the putty retains a permanent change of shape. Which conclusion is correct?

48 / 50

48. Two solid materials X and Y are compared. Their thermal conductivities and specific heat capacities are:


Equal-sized slabs of X and Y are maintained between the same two temperatures. Separately, equal masses of X and Y receive equal quantities of heat with no phase change. Which comparison is correct?

49 / 50

49. A liquid has

It is placed in a capillary of radius . The liquid density is , and . Treat the meniscus as part of a sphere. What are the angle of contact, capillary rise and radius of curvature of the meniscus?

50 / 50

50. A wetting liquid rises vertically through in a narrow capillary when the tube is vertical. The same capillary is then inclined so that its axis makes with the horizontal, while the lower end remains in the same reservoir. Neglect changes in liquid properties and contact angle. What are the new vertical rise and the length of the liquid column measured along the capillary above the outside liquid level?

Your score is

Share your achievement!

LinkedIn Facebook
0%

Complete 100% of the Progressive Test coverage to unlock Mistake Review.
Complete 100% of the Progressive Test coverage to unlock Certificate Challenge.
Subscribe
Notify of
guest
0 Comments
Scroll to Top