Rotational Motion Mock Test – NEET Physics
GKaim: Measure | Improve | Achieve

Rotational Motion Mock Test – NEET Physics

Progressive Test — Guest First Round

0%

Rotational Motion – Progressive Test

Welcome to the Progressive Test.

Click Start Test to begin the loaded practice round.

Good luck!

1 / 50

1. In a rigid body undergoing non-zero rotation about a fixed axis, two distinct particles and remain stationary. Their coordinates are and . Another particle has speed . At the same instant, particle has speed

2 / 50

2. A thin circular ring of mass and radius is considered about an in-plane axis Q parallel to a diameter and at distance from the centre. It is found that equals the moment of inertia of the ring about its central perpendicular axis. Another axis P is perpendicular to the ring and is displaced by the same distance from the central perpendicular axis. If equal torques act separately about P and Q, which pair is correct?

3 / 50

3. A horizontal bar lies along the -axis with pivot at . A downward force acts at , an downward force acts at , and a upward force acts at . Take anticlockwise moment as positive.

The net moment about is

4 / 50

4. A uniform thin wire is bent to form a right-triangular frame with vertices at , and . The centre of mass of the wire frame is

5 / 50

5. A horizontal rod of weight is suspended by two vertical strings attached at points and from its left end. A load is attached at the right end of the rod. Which conclusion follows from the equilibrium equations if both strings are assumed to remain taut?

6 / 50

6. The angular position of a rigid body rotating about a fixed axis is

in radians, where is in seconds. Which statement correctly compares its rotational state at and ?

7 / 50

7. A thin circular ring of mass and radius is considered about two tangent axes. Axis P is perpendicular to the plane of the ring and tangent to it. Axis Q lies in the plane of the ring, is tangent to it, and is parallel to a diameter through the centre. The ratio is

8 / 50

8. A force acts at

Initially,

It is then replaced by

For a body constrained to rotate about the fixed -axis, which statement is correct?

9 / 50

9. Consider the following statements about conservation of angular momentum.
Statement I: If the net external torque about a specified fixed axis is zero, the corresponding total angular momentum is conserved.
Statement II: Internal friction can change the angular momenta of individual parts while leaving the total angular momentum of an isolated system unchanged.
Statement III: Conservation of angular momentum necessarily implies conservation of rotational kinetic energy.
Statement IV: A non-zero external force whose line of action passes through the chosen rotation axis can have zero torque about that axis.
Which combination is correct?

10 / 50

10. A rotationally symmetric plane lamina has moment of inertia about the axis through its centre , perpendicular to its plane. An in-plane axis , parallel to a diameter through and away from it, has moment of inertia . Another axis is parallel to and from it. The mass of the lamina and are

11 / 50

11. Two coaxial parts of an isolated system have moments of inertia and . Initially both are at rest. An internal motor starts them rotating in opposite senses until their relative angular speed is . If no external torque acts, their angular velocities are

12 / 50

12. A rigid composite body consists of component A of mass whose centre of mass is initially at , and component B of mass whose centre of mass is initially at . Component A is translated through . Simultaneously, mass is redistributed internally within component B, without changing its total mass, so that its own centre of mass shifts through . The final centre of mass of the complete body is

13 / 50

13. A uniform thin rectangular wire frame is centred at the origin. Its horizontal sides have length and lie at ; its vertical sides have length and lie at . The right vertical side is removed completely. A point mass equal to half the mass of that removed side is then attached at the upper-right corner .

The centre of mass of the final system is

14 / 50

14. A rigid body is constrained to rotate about the fixed -axis and has moment of inertia . A force initially acts at the point . It is then replaced, at the same point, by the force

Which statement correctly describes the change in rotational response about the fixed axis?

15 / 50

15. For a rigid body rotating about a fixed symmetry axis, a graph of axial angular momentum versus angular velocity is a straight line through the origin and passes through . In a separate experiment on the same body about the same axis, the graph is a straight line of slope .

The moment of inertia, net axial torque and angular acceleration in the second experiment are

16 / 50

16. The angular position of a rigid body rotating about a fixed axis is

in radians. At and , respectively, which description of the angular motion is correct?

17 / 50

17. For a coplanar force system acting on a rigid body, the net torque is found to be zero about two distinct points A and B. Which conclusion is necessarily correct?

18 / 50

18. A rigid object is observed in three different motions.
Situation P: Every point undergoes the same displacement vector over a short interval, and the body's orientation does not change.
Situation Q: One line of particles remains fixed while all other particles describe circles centred on that line.
Situation R: The body's orientation changes while no line fixed in the body remains stationary in the laboratory frame.
Which identification is correct?

19 / 50

19. Assertion: A rigid body acted upon only by a couple is not in complete mechanical equilibrium, even though the resultant force on it is zero.
Reason: A couple has zero resultant force but a non-zero resultant torque.

20 / 50

20. A couple consists of two forces of magnitude whose parallel lines of action are apart. A single additional force is then applied along a line whose perpendicular distance from a specified point is . Its moment about opposes the couple. The magnitude of the net moment about is

21 / 50

21. Two aggregates of masses and are fixed at and , respectively. A quantity of material is transferred from the aggregate at to the aggregate at , without changing either position. As a result, the centre of mass shifts toward by . The final mass ratio of the aggregate at to that at is

22 / 50

22. A system has initial angular momentum

For the next , two constant external torques act simultaneously:

The final angular momentum is

23 / 50

23. A force

acts at the point whose position vector from origin is

A new origin is chosen at

relative to . The torques of the same force about and , respectively, are

24 / 50

24. A disc of moment of inertia rotates with angular velocity about a frictionless vertical axis. A particle of mass approaches in the horizontal plane with speed along a line whose perpendicular distance from the axis is . Its angular momentum about the axis is opposite to that of the disc. The particle strikes the rim and sticks. The final angular velocity is

25 / 50

25. Consider the following statements about the centre of mass and centre of gravity of a rigid body.
Statement I: In a sufficiently uniform gravitational field, the centre of gravity coincides with the centre of mass.
Statement II: Under the same condition, the body's weight may be treated as acting through this common point in equilibrium calculations.
Statement III: For every non-uniform rigid body, the centre of gravity must coincide with its geometric centre.
Statement IV: Changing the point about which torques are calculated physically shifts the centre of gravity of the body.
Which combination is correct?

26 / 50

26. For a system rotating about a fixed axis, the external torque is positive from to , negative from to , and the signed areas between the torque-time graph and the time axis over these two intervals are equal in magnitude. The moment of inertia at is , while at it is . The initial angular velocity is .

The final angular momentum and angular velocity are

27 / 50

27. A uniform horizontal rod of mass and length is hinged at its left end and is initially held in equilibrium by a vertical string attached to its right end. The string is suddenly cut. Neglect hinge friction. The tension just before cutting and the magnitude of the acceleration of the free end immediately after cutting are

28 / 50

28. A uniform circular disc of mass and radius is considered about two tangent axes. Axis P is perpendicular to the plane of the disc, while axis Q lies in its plane and is parallel to a diameter. Starting from rest, the same constant torque acts for the same time about each axis in separate trials. The ratios and are

29 / 50

29. A family of geometrically similar solid cylinders is made from the same material. Every linear dimension of cylinder B is twice the corresponding dimension of cylinder A. Their moments of inertia about their own symmetry axes satisfy

30 / 50

30. A system has initial angular momentum . A constant external torque directed along is then applied and maintained. Consider the following events:
P. The angular momentum is still along but has a smaller magnitude.
Q. The angular momentum becomes zero.
R. The angular momentum points along with a small magnitude.
S. Continued action of the same torque increases the magnitude of the angular momentum in the direction.
Which sequence correctly describes the possible chronological evolution?

31 / 50

31. Three point masses rotate rigidly about a fixed axis. A mass is at perpendicular distance , a mass is at , and a mass is at an unknown distance . A net torque of produces angular acceleration . The mass is then moved onto the axis while the same net torque is maintained. The value of and the new angular acceleration are

32 / 50

32. Which statement correctly characterises a rigid body undergoing pure rotation about a fixed axis?

33 / 50

33. A system initially has angular momentum

A constant external torque

acts for . Which statement is correct?

34 / 50

34. A rigid disc rotates about a fixed -axis through its centre. At one instant, a force acts along at the point , a force acts along at the point , and a radial force acts along at the point . The moment of inertia about the fixed axis is . At that instant points along .

Which statement is correct?

35 / 50

35. For a plane lamina of mass , the moment of inertia about the perpendicular axis through its centre of mass is . About an in-plane axis through the same point,

An axis , parallel to the perpendicular in-plane axis , is at distance from the centre and has

If is the radius of gyration about , then and the ratio of angular accelerations under equal torques are

36 / 50

36. A thin rod of length extends from to . Its left half has uniform linear mass density , while its right half has uniform linear mass density . Its centre-of-mass coordinate is

37 / 50

37. A particle of mass is at and another particle of mass is at . Without changing their positions, the mass of the particle at is doubled. The new centre-of-mass coordinate is

38 / 50

38. A thin plane lamina initially lies entirely in the -plane, and its moments about three mutually perpendicular axes through point satisfy

The lamina is then bent into a non-planar three-dimensional shape without changing its mass. Which statement is correct for the bent body?

39 / 50

39. A rigid body rotates about the fixed -axis with

A force

acts at

If this force produces angular acceleration

the value of is

40 / 50

40. Consider the following linear–rotational correspondences for motion along a line and rotation about a fixed axis.

Linear quantity/relation Proposed rotational analogue
P. Displacement Angular displacement
Q. Momentum Angular momentum
R. Force Torque
S. Mass Angular velocity

Which correspondence is incorrect?

41 / 50

41. A uniform disc of mass and radius is constrained to rotate about a fixed axis perpendicular to its plane and tangent to the rim at point P. The diameter through P is horizontal. An upward force acts at the diametrically opposite point, while an equal downward force acts at the centre of the disc. Neglect any torque of the pivot reaction about P. The angular acceleration is

42 / 50

42. Every mass element of a rigid body lies at a perpendicular distance between and from a specified axis. A measurement claims that the radius of gyration about this axis is . Which conclusion is correct?

43 / 50

43. A particle of mass is fixed at , while another particle of mass is fixed at , where . Match each value or limiting value of with the corresponding value of .

List I List II
P 1
Q 2
R 3
S 4

44 / 50

44. Particles of masses and are fixed at and , respectively. An additional mass is attached at each particle without moving either one. The displacement of the centre of mass caused by this change is

45 / 50

45. A mass is fixed at and a mass is fixed at . The two masses rotate rigidly about the fixed -axis with angular velocity .

The total angular momentum about the origin is

46 / 50

46. A plane lamina has moments of inertia

about two mutually perpendicular axes in its plane through the same point. A third axis passes through that point perpendicular to the lamina. If the same net torque magnitude is applied separately about the - and -axes, which pair is correct?

47 / 50

47. Two points and of the same rigid body are at perpendicular distances and , respectively, from a fixed rotation axis. During a certain rotation, the arc travelled by exceeds that travelled by by . The angular displacement of the body and the arc travelled by , respectively, are

48 / 50

48. A force acts on a rigid body at a point whose position vector from a chosen pivot has magnitude . If the force magnitude is and the angle between and is , the magnitude of the moment of the force about the pivot is

49 / 50

49. A uniform horizontal rod of mass and length is supported vertically at its two ends A and B and is initially in equilibrium. The support at B is suddenly removed, while A becomes a frictionless hinge so that the rod begins rotating about A. Which pair gives the upward reaction at A immediately before removal and immediately after removal?

50 / 50

50. Two uniform thin rods of the same material and cross-sectional area are joined end-to-end along the -axis. A rod of length extends from to , and a rod of length extends from to . The shorter rod is then uniformly coated so that its mass becomes twice its original value, without changing its dimensions. The displacement of the centre of mass due to coating is

Your score is

Share your achievement!

LinkedIn Facebook
0%

Complete 100% of the Progressive Test coverage to unlock Mistake Review.
Complete 100% of the Progressive Test coverage to unlock Certificate Challenge.
Subscribe
Notify of
guest
0 Comments
Scroll to Top