Estimating & Costing Online Test – Paper 3

1. The minimum space left from the property line (In Kathmandu valley) for the provision of window/door is

2. Which of the following is not considered while preparing the item rate estimate?

3. For estimating painting area for iron grillwork over a door or window opening, the area measured will be:

4. During the calculation of RCC, the amount of steel deducted is

5. The weight of cement in one bag is

6. The unit rate of items written by the contractor in BOQ is in numeral as well as alphabetical form. Which one is preferred?

7. According to ISI method of measurement, the order of sequence is:

8. The useful part of the livable area of a building is also known as

9. Rate analysis prepared by the ministry of transport and work includes

10. The thickness of slabs and beams must be measured to the nearest

11. Which of the following is known as job overhead?

12. The volume of concrete for a reinforced concrete isolated sloped footing with top and bottom areas equal to A1 and A2 and with a height equal to h is given by:

13. The full form of VAT is

14. Full payment of the contractor is done

15. In detailed measurement, the sequence of dimensions is written:

16. The essential requirements to prepare a good estimate are

17. Compound amount of Rs. 100 in 4 years @ 4% interest

18. Liquidated damage is directly related to

19. In the case of a roof truss made of steel, rivets, bolts, nuts, etc., normally account for

20. The unit of measurement for concrete work in R.C.C. is

21. The measurement of steel grills is taken in terms of

22. The process of calculating the amount of material, labor, and equipment for a unit of work together with overhead and profit for the contractor is:

23. Steel formwork can be used up to about.........times.

24. In the specification of earthwork in foundation trenches, drains, etc. lift ordinarily specified is

25. The portion which is wrongly excavated by the contractor is to be filled

26. During the excavation of soil, some portion is left without disturbing, which is known as

27. In the analysis of rates, the profit and overhead for the contractor are generally taken as

28. Which one information is not found in specification?

29. The unit of measurement for electric wiring or electrification light, fan plug points is

30. Bill of quantities is prepared based on:

31. The types of work done by the use of labor but not material, equipment, etc., are known as:

32. For small residential buildings, the cost installation and electrification are made as:

33. In CGI sheet roofing, the overlap along the length of the sheet should not be less than?

34. The unit of measurement for woodwork in door and window frame, rafters, beams, roof trusses, etc., is

35. At present, the approximate cost of a Residential building per square foot in Kathmandu is

36. The unit of payment for A.C. sheet roofing is in

37. Dismantle means

38. What is the minimum period for which the lime concrete in the foundation be left wet without the construction of masonry over it?

39. Carpet area does not include the area of

40. The tender is:

41. As per norms prepared by the ministry of transport & works, one porter can carry a weight of

42. An estimate is:

43. The area of the segmental portion of an arch with span I and rise r is approximately given by

44. The unit of payment for blasting of rock including stacking is

45. The value of the dismantled material less the cost of dismantling is called

46. The method of valuation of a building as used by commercial banks is based on:

47. Actual cost of construction plus certain profit is paid to the contractor. Such a contract is known as

48. For brick construction, the lime-sand mortar is

49. 1 British gallon=.........litres.

50. A document showing the list of quantity of various items of works required for the completion of any project is known as